SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Radio Communication / Antennas / Ham, Amateur Radio Antennas
PROVIDE YOUR OWN ELEMENT WIRE FOR THIS END FED HALF WAVE TRANSFORMER.Wire length required: 66' 6" for 10 thru 40 meters, 133' for 10 thru 80 meters.
Each antenna is custom built, tuned, and tested for maximum performance.
Ideal for HOA, POTA, SOTA, and Field Day installations.
Employs one T-140 toroid in a unun transformer wound with 18awg copper magnet wire.
Stainless steel hardware.
Matched for 50 ohm coaxial cable with PL-259 connector.
SWR aprox. 1.5/1, slightly higher on 10 meters.
Weather proof encased circuitry eliminates faulty and corroded connections and components.
Conservatively rated at 50 watts SSB & CW, 35 watts on DIGITAL, intermittant amateur service.
Easy installation, many configurations work well.
Works well even at low heights and on small lots.
Operates 10 15 17 20 & 40 meters,(80 meters with longer element wire) with single 50 ohm coaxial transmission line, no antenna switch required.
Lower noise level on receive than dipole and vertical antennas because of closed circuit input.
This is probably the best performing multi-band wire antenna I have built and used in the past 50+ years. The performance is surprsing at any power level considering the bandwidth and appearant low angle of radiation (for dx), even when installed at low heights above ground.
For safety purposes keep antennas clear and away from power lines.
Returns Accepted for this item if it's within 30 Days