SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Radio Communication / Antennas / Ham, Amateur Radio Antennas
For Sale: A good condition medium duty CDE Rotor package with lower mast support clamp in place. This was recently serviced preparing for an install which did not happen. Trademarked as the BTi-A "Big Talk" antenna rotor, it is built in CDE's traditional cast aluminum bell housing and is serviceable. It will come to you ready to mount and use. But, as you can see in the pictures, you should put a grommet or rubber-guard in the hold which the cable passes through at the rotor entrance. The rotor control cable is as new and if my arithmetic is correct (using Avg Dia x Pi x # of Turns) the cable is 75 to 80 feet long. The controller allows for 4 pre-sets regards position as well as a dial it yourself rotational encoder. Ideal for a rotating dipole 20m and above. Should be fine for a 2 el beam 20m and up or a VHF/UHF Yagi using the mast support section. The Hygain TH3Mk4 has a wind surface area of 4.6 which suggests if you remove the lower mast adapter and bolt the rotor down to a section plate, it should handle that as well. The bottom line is "THINK". Condition: Tested and seems to perform as intended. This rotor package utilizes normal 115 VAC. We are not experts and doing our best to honestly describe this package. It is not possible to anticipate all conditions that a controller this versatile is subject to. It responded positively to the basic functions we could understand. So, keep in mind, this is sold strictly as shown and as is. Terms : Sold strictly AS IS and is not returnable. We are downsizing, not retailing.