SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Radio Communication / Antennas / Ham, Amateur Radio Antennas
Note: This will fit a Jeep Cherokee KL (2014-2023) with a manual liftgate/hatch. Until it's tried and confirmed by someone trying it on a model with a powered liftgate I don't know if it will also fit on those. If you have a KL with a powered liftgate, please send me a message before buying. Thank you. For sale here is a hatch mount NMO antenna bracket fitting the Jeep Cherokee KL (2014-2023) with a manual (i.e. non-powered) liftgate. The bracket is made from heavy-duty 2 mm stainless steel, and comes in a brushed finish. It mounts under the hatch gas damper bracket, and uses those screws for a very secure mounting. In addition to the mounting holes there's a 5 mm hole. This can be used to add an additional, small grounding point by drilling a small hole for a self tapping stainless steel screw. The bracket also comes with cover labels on the NMO mount and grounding holes. This allows you to paint the bracket while keeping the grounding contact points free of paint. For SWR, you mileage will obviously vary, but I've obtained 1.2:1 with a Larsen NMOQ 1/4 wave VHF antenna, and 1.3:1 on VHF and 1.2:1 on UHF with a Tram 1181 dual band antenna. To mount: 1. Support the hatch with something - a broom stick or whatever fits. It won't hold up on a single damper. 2. Remove the screws from the hatch gas damper hinge. 3. Slide in the antenna bracket under the gas damper hinge. 4. Fit the gas damper screws again, but don't tighten them completely. 5. Adjust the antenna bracket so the antenna will be as close to vertical as possible. 6. Tighten that gas damper hinge screws. Please see pictures for reference. Make sure to select the correct side - LEFT or RIGHT - for the side if the car you intend to fit the bracket. Back story: Due to interference from the engine and cabin electronics, I needed a way to mount my ham radio antenna at the rear next to the hatch. I didn't find anything already existing, so I ended up designing it myself and have a machine shop make it for me. The startup costs for a single bracket is eyewatering, so while at it I had the shop make a small run of 10 left and 10 right side brackets, allowing me to help out others who are looking for a similar solution - and recoup some of the tooling and setup costs. I am not doing this as a business, so once this batch is gone it's gone.